Page 60 - Geko 01_2020

| Original accessories

The useful and practical accessories are available by GEKO directly at the You may find the correct order numbers for each of the shown accessories in
factory on require; readily implemented in your genset. our accessory list for each genset.

GW 308 Emergency power
Insulation control unit Silent Economic
change- over

Additional safety measures against Additonal safety measures against The manual emergency power Silent Economic – The load depen-
contact voltage with the signal contact voltage according to VDE change- over (MNU) is the simple ding rotation speed regulation pro-
lamp and automatic shutdown 0100 part 410 with a signal lamp. and economic solution of an vides long operation terms due to
are applied more and more in the IT-network with constant insulation emergency standby system for low fuel consumption and hereby
field of pipe installation for gas and control between network conduc- everybody. Single- and three-phase is very gentle to the environment.
water. tor and safety conductor. types available.

RCD protection switch Wheel set Volt-/Amperemeter Grounding set

RCD protection switch incl. For gensets with a tubular frame or Analog implemented measuring Consists of a grounding cable
grounding set. Alternative safety sound absorption housing. instruments to control the (16mm², 2.5m) and a grounding
measure against contact voltage. With a manual for a simple voltage and current values. In case spike (45cm).
installation for retrofitters. Editions of aggregates with three-phase
are specific or single-phase current a voltage
change-over switch is installed in
the switchbox

Exhaust pipe Exhaust pipe adapter ATS Control Panel Nano CPN external

ComAp ATS controller
• Multi purpose display
• Voltage display
• Currency display
• Frequency display
• Counter for operating hours
• Display of error messages with
history
• Display of operation mode
• Network monitoring and
automatic start of the power
generator in case of network
failure
Flexible metal pipe for deflecting Is necessary for the connection of
exhaust gases. Length 2.5m up to the exhaust pipe to the genset.
5m depending on each type.
Do not operate in enclosed rooms.
Attention! Danger of poisoning!

60